In this guide, you will learn how to correctly install a dual float remote tank monitor.

Add reducer if needed. If the port on your tank is 4" add a 4" to a 2" reducer. If your port is 3" add a 3" to 2" reducer. If your port is 2" continue to the next step ( NO reducer is needed).

STEP 2

Slowly lower the floating probe down through the reducer or 2" port hole.

Connect the Short 18" cable to the Comm box and to the probe below it.

Connect the longer cable from one probe to the other. Secure the cable zip ties to keep it out of the way so it will not cause a tripping hazard or run the risk of being accidentally cut.

Attach the iWell Remote Communication box as shown in the image below.

Attach the antenna to the Remote Communication box.

Connect the white plug on the end of the battery cable to the white receptor on the board next to the battery.

STEP 8

Gauge the tank to the top level for calibration purposes

Make sure the solar panel is facing south.

STEP 10